DURALOK INSTRUCTIONS:
Model HT3

Your Duralok Torque Wrench is pre-set to slip when 60 inch pounds of torque are applied. The factory set maximum torque should be more than adequate to properly secure parts to a work bar. If you require a different setting for a specific job on your anodizing line, please contact our offices at 1 (800) 659-5506 for further instructions.

Tightening:

Pull the blue sleeve up or towards the "T" handle in order for the torque wrench to ratchet as you tighten the screw into the Duraclamp^® frame during the racking process.

Loosening:

Slide the blue sleeve down or away from the "T" handle to lock the torque wrench in place & prevent ratcheting for the unracking of Duraclamps^®.